How to Setup a Printer (printing from your handheld device)

How to Setup a Printer (printing from your handheld device)

Each handheld device can be setup to print to one printer at a time.

These settings are stored with each user's log in profile on that specific device.

The below list is a list that has been tested with the Easy RFID Pro operating on an Android device (although most modern printers should have no problem printing our reports if properly setup).

  • All HP Laser jet printers
  • Lexmark 260
  • Ricoh 811DN

To setup your printer:


  1. Log into the Easy RFID Pro app on your device.
  2. Navigate to the reports icon 
  3. Click the printer button (located the bottom right corner of the page)
  4. The system will prompt you to type the IP address and port number of the printer. Ask the IT person at your company to find the IP address of the printer you wish to print to.  In most cases the printer port will be 9100. If it is different your IT administrator should be able to tell you.
  5. Once configured, tap the print button at the bottom of each report you wish to print.

Additional Notes:
The pages are set to print landscape, single sided. The format of the predefined printed reports cannot be changed at this time

    • Related Articles

    • ZQ630 Mobile Printer Setup Instructions

      Step 1 - Insert the battery. Step 2 - Open the protective cover on the printer and plug in the power cable. Step 3 - Open the printer to install the roll of labels.  Step 4 - Pull the media supports apart and insert label roll, then close the lid and ...

    • How do I reconnect my mobile printer to my handheld device?

      STEP 1:      Press the TOUCH SCAN button at the bottom of the screen STEP 2:      Select SET PRINTER STEP 3:      Turn on the printer STEP 4:      Flip over the printer and locate the Bluetooth bar code STEP 5:      Scan the barcode with your RFID ...

    • MC333XR Scanner Setup Instructions

      STEP 1:      Attach the battery to the scanner STEP 2:      Power the device on by pressing the red button in the lower right corner STEP 3:      Connect to your WiFi network by holding down the WiFi symbol in the upper right corner of the screen ...

    • Scanner Not Connecting to the Printer via Bluetooth

      The first time you pair your scanner to the printer, you need to put the printer into discovery mode. Make sure that bluetooth is enabled on your scanner. HOW TO PUT PRINTER INTO DISCOVERY MODE: Hold down the FEED button on the printer until the ...

    • How to check the warranty on any Zebra device

      To check the warranty status on any Zebra device, make sure you have your serial number handy. Click the link below and enter the serial number of the device. CLICK HERE TO CHECK WARRANTY